FAQ

FAQ

	FREQUENTLY ASK QUESTIONS

	a. What are KHANSGRATES
	b. How to Order ?
	c. Glossary of Terms

What are KHANSGRATES?
KHANSGRATE are gratings that has our logo stamped on the edge of our grating panel. It is available in numerous combinations of load bar depth and thickness, load bar pitch and cross rod pitch to suit any range of applications. The various types of standard gratings are shown in the following pages of this brochure.

A typical KHANSGRATES grating

How to order?

Go To Top Back

1. You, as our most concerned customer, are encourage to approach us for guidance and support on the knowledge of types of gratings suitable for your industry. This allow optimum usage of type of gratings, hence allowing you, our valued customer, to lower your cost in our KHANSGRATES purchasing. Our Sales and Factory department shall provide their expertise to make out the best of your needs.

2. You can proceed on by deciding on the expertise provided by our experience personnel on the below specification as of:

a. Type of Grating

Specify the type of KHANSGRATE Grating required by

reference of our three main types of products.

c. Finishing

Nominate the type of finishing required i.e. untreated, painted

or galvanized.

d. Anchoring Methods

Where fastening clamps units are required, select any of our

three types of clamping units available. Clamping units should

be provided for on the basis of a minimum of 4 units per

panel.

b. Dimensions

-Nominate number of standard 1.0 x 6.1m / 0.9 x 6.1m

panels required.

-Nominate whether banding is required.

-For non standard panels, nominate dimension for length

and width of individual panels.

-Where large areas of flooring is to be covered, provide:

i) shop drawings of grating floor zone.

ii) detail drawings of beams, pillars and their joints.

iii) setting positions of stairs and procedures of stairs,

railing piping and etc.

iv) sizes and locations of cutouts, kick plates and nosing.

-For stair threads, select from our ranges of standard

types and nominate dimensions and quality.

Our recommended length and widths should be

nominated for economical orders.

GLOSSARY OF TERMS:

Load Bearing Bar, Transverse Bar, Binding Bar, Deep Binding Bar, Toe Plate (Kicking Plate), Erection Clearance

Span, Length, Nett Area, Gross Area, Cut-Out, Straight Shaping, Curved Shaping, Width, Pitch

Starter, Serrations, Slip-Resistant Edging, End Plate, Curb Angle.

Go To Top Back

Webmaster: Worldwide Home Page